Dooger's Easy Products

Installation

For best results, Dooger’s Dead Nuts On (DDNO) Parking Guide should be applied to a clean, dry, solid-surface garage floor. Position car where you would ultimately like it to be. For installation, any tire can be used. For this demonstration, however, we are using the left, rear tire. Place the guide behind and against the tire as shown in the picture below. Trace around a corner and along a side. Remove the guide and back out the vehicle. Peel off the tape backing on the guide. Place the parking guide on the floor using the tracing as a guide. Press firmly.  

Place

Trace

Peel

Press

To Use: Drive forward until you feel the bump of the vehicle going over the parking guide. Stop. For best adhesion, drive the vehicle back and forth 2-3 times slowly over the guide to set in place.

Warning: This product is intended for use as an indoor parking guide only. It is not intended for use as a vehicle stop.

Packaging made with 100% post manufacture recycled content. 

The inventor of Dooger’s Dead Nuts On parking guide holds a U.S. Usage Patent.